Capacity
All power take-offs are particularly designed for generating hydraulic pumps to SAE J744C series ‘B’ specification with splined insight shaft and either two-bolt or four-bolt fixing. The maximum power which may be transmitted is definitely 22 KW (29.5 bhp) per 1000 rev/min engine speed; this equates to a torque of 209 Nm (155 Ibf.ft. – 21.33 kgm.).For PRM1000 the clutched power take-off provides pump rotation the same as the engine, where as the direct drive power take-off for the PRM500 and PRM750 will give opposite rotation. Power to the pump isn’t affected by the normal use of the gearbox for propulsion duties. All ancillary power circuits driven by PRM power take-offs ought to be designed in accordance with the suggestions of the hydraulic equipment manufacturer, and should be correctly safeguarded against overloading.
Installation
PRM power take-off models fit on the rear face of the primary gearcase and are driven by the input shaft; consequently they may be operated all the time whilst the engine is usually running, The energy take-off replaces the end cover which is normally installed and performs the features of the finish cover by sealing the gearbox against lack of oil and properly positions the insight shaft back bearing. Power take-off models provide the link between the gearbox and the hydraulic pump.

Direct Drive Power Take-Off
On the PRM500 and PRM 750 the immediate drive power take-off is definitely driven directly from the gearbox insight shaft; consequently it will operate at all times when the engine is usually working, and since there is no clutch for disengagement of the hydraulic pump, provision must be made in the auxiliary hydraulics circuits for pressure by-complete to the reservoir when capacity to the pump is not required. A set of 1:1 ratio gears, providing sufficient offset between the gearbox result shaft and the centreline of the power take-off to ensure there is enough clearance between the hydraulic pump and propeller shaft coupling.

Specifications
Ever-Power PTO Shaft
Series 6
1-3/8 inch 6-spline tractor end yoke and a 1-3/8 inch 6-spline FD2 clutch on the implement end
FD2 clutch
Collapsed length: 47 in.
Extended length: 60 in.
62 HP at 540 RPM
98 HP at 1000 RPM
FD2 clutch attaches with one bolt that suits a groove on input shaft of rotary mower

Do your study … you’ll find people are completely satisfied with pto gearbox.