An alternate system uses a fog or great mist injected in to the intake air stream. Although many commercial systems can be found, growers can assemble and set up their own system using a high pressure piston pump and fog nozzles. The basic components are shown in Fig. 1. A two-stage system managed by a two- stage thermostat allows more water to be employed on excessively warm, shiny days. Temperature settings ought to be 5-10°F apart.

Algae development in the pads may become a problem that may decrease the effectiveness of the machine and lead to accelerated deterioration of the pads. The addition of an algaecide to the water supply will help in control.

It is desirable, especially in hard water areas, to add a wetting agent to the drinking water to obtain additional uniform wetting of the pads. A commercial materials or liquid home detergent at the rate of 2 tablespoons per 100 gallons can be used.

Drinking water for the pads ought to be clean and lower in mineral content to prevent clogging and coating of the pads. A pump, pipes and gutters are accustomed to recirculate the drinking water. A flow rate 113 gallon per minute per linear foot of pad program ought to be provided to guarantee adequate wetting.

In the most typical cooling system (fan and pad), the fans draw air through wet pads that prolong the length of 1 endwall or sidewall. Aspen and covered cellulose are common pad materials that always have life of 1 to 3 years. Approximately one square foot of pad are is necessary for 20 square feet of floor area.

Sight more videos concerning Greenhouse Auto Vent.